Printed flat, before the garment exists
Printing a cut panel instead of a finished garment is the advantage of printing inside a cut and sew run. A design can extend to the edge of a panel, cross where a seam will later be, or sit over a pocket position, none of which is possible on an assembled garment. It also means no hoop marks and no distortion around seams.
Ink systems and what each is for
- Plastisol is the workhorse: opaque, durable, vivid on dark fabric, with a slight surface hand feel.
- Water-based ink soaks into the fibre for a soft, almost invisible hand. Best on light cotton; less opaque on dark.
- Discharge removes the garment dye and replaces it with pigment, giving a very soft print on dark cotton. Results vary with the dye used, so always approve a strike-off.
- Puff rises above the fabric for a raised 3D finish. See puff print hoodies.
- High-density builds a sharp-edged raised block, flat on top rather than rounded.
- Metallic and specialty inks for foil, glitter and reflective finishes.
Cost is driven by colours, not size
Each colour needs its own screen, its own set-up and its own pass through the press. A one-colour print across a whole back costs less than a four-colour chest logo. If your budget is tight, reduce colours before reducing size. Simulated process printing can reproduce photographic artwork, but it uses several screens and is only economical on larger runs.
Artwork
Send vector files with each colour separated and Pantone references. For photographic artwork send the highest resolution you have at the finished print size. We return a printed strike-off on your actual bulk fabric before the run, because ink colour reads differently on different fabrics and the only reliable check is a physical one.
Curing is what makes a print last
A screen print fails when it is under-cured, not when it is badly printed. The ink has to reach its full curing temperature through the full deposit. This is the most common cause of prints that crack or wash out, and it is also invisible on a fresh garment, which is why we wash-test the strike-off rather than only looking at it.
Cartons labelled and packed for export from Sialkot
Questions buyers ask
Does a print with more colours cost more?
Yes. Each colour needs its own screen and press pass. Print size matters far less than colour count.
Which ink should I choose?
Plastisol for opacity and durability, water-based for a soft hand on light cotton, discharge for a very soft print on dark cotton, puff or high-density for raised effects.
Can you print photographs?
Yes, using simulated process printing with several screens. It is economical on larger runs; for small runs a transfer or sublimation may suit better.